Hi there!
I have bought a house with an alarm system installed. It's labelled as an ADT Safewatch Pro 2000, which the FAQ helpfully identified as an Ademco (now Honeywell) Vista 20se. It is long out of contract.
I have followed the directions here to get to programming mode, get and reset the installer code, and set the master user code to something I know. That was well documented here, and I really appreciate, so now we can shut the alarm off if some dingbat arms it. I also cleared the phone numbers to keep it from bothering ADT, and set the "single button alarm" to false, so it takes a code to arm it. (I also replaced the battery, but that was pretty obvious.)
Thank you for all the excellent information you've collected here. It made this possible.
Is there a way to get a clear list of the zones defined on the alarm, and what their settings are? Preferably to also show the nicely defined textual names the zones have defined? (Someone set all that up on this; very clearly done.)
How can I tell what the system has defined?
Also, I can't figure out how to open the motion detector. It's in "check" state, and has no light - I bet it's battery is dead. How do I get into it? There's a panel on the top which reveals... nothing.
Get zone list on Vista 20se?
I have bought a house with an alarm system installed. It's labelled as an ADT Safewatch Pro 2000, which the FAQ helpfully identified as an Ademco (now Honeywell) Vista 20se. It is long out of contract.
I have followed the directions here to get to programming mode, get and reset the installer code, and set the master user code to something I know. That was well documented here, and I really appreciate, so now we can shut the alarm off if some dingbat arms it. I also cleared the phone numbers to keep it from bothering ADT, and set the "single button alarm" to false, so it takes a code to arm it. (I also replaced the battery, but that was pretty obvious.)
Thank you for all the excellent information you've collected here. It made this possible.
Is there a way to get a clear list of the zones defined on the alarm, and what their settings are? Preferably to also show the nicely defined textual names the zones have defined? (Someone set all that up on this; very clearly done.)
How can I tell what the system has defined?
Also, I can't figure out how to open the motion detector. It's in "check" state, and has no light - I bet it's battery is dead. How do I get into it? There's a panel on the top which reveals... nothing.
0 commentaires:
Enregistrer un commentaire