lundi 16 février 2015

Burning dust smell when fan left on

Let me start by saying the furnace is clean and there is no burning dust smell if I leave the fan off (ie only comes on when the furnace calls for heat). However if I leave the fan on 24/7, when the furnace goes into heat mode, you get the distinct burning dust smell.



My guess is running the fan 24/7 blows dust into the combustion chambers ?



I would have thought a MERV11 filter would have stopped that...



Any thoughts?

Burning dust smell when fan left on

Build Garage Over Basement

Searching this forum, I found this thread http://ift.tt/1CDcxte where Charlie (mascdm) described a project [of building a basement over a garage] very similar to one I'm considering. Does anyone care to estimate what this should roughly cost today? Feel free to make assumptions. What other construction methods should I consider?



Really appreciate anyone's help.

Build Garage Over Basement

Interconnected smoke detectors problem

I currently have a pair of First Alert 3120B's connected to each other with the red/orange wire with about 30ft of 14 gauge wire.



When I connected one of them to AC power, the other one went off with a test and I thought that was it, I got them to work. I proceeded to do a real test with smoke, so I smoked one of them, it went off BUT the other one does nothing, it acts as if they are not connected together at all.



I have gone through 4 different ones and they are all the same, I really don't understand what is wrong. Works like a charm by themselves but I want that interconnect to work.



Solid green light on both detectors mean AC power, batteries are in and test just fine by themselves. Do my smoke detectors just not like each other?



AC power is provided with spliced electrical plugs, plugged into outlets since I live in an apartment I can't go into walls/ceilings.

Interconnected smoke detectors problem

Boiler Not Heating Water

Hi all. This is my first post. If you have any insight to my situation, I would appreciate it.



About two years ago, my Weil-Mclean boiler cracked and was replaced under warranty. After it was replaced, the cast iron pipe coming from the the boiler started to leak. That fall, the company that did the work came out and replaced the leaky connection.



That winter and this winter, when it is really cold outside, the boiler struggles to get the house temp above 63 degrees. This is the case even after running continuously for hours and hours.



The temp gauge reads about 130 and the pressure gauge reads 60psi. While looking at the specs of the unit I noticed thath the max pressure for the unit was 50psi. Is it possible that the replacement part being narrower than the cast iron it replaced be causing the pressure to be too high? Would this cause the boiler to not heat properly? Below are some pictures.



[IMG] [/IMG]

[IMG] [/IMG]

[IMG] [/IMG]



This copper section is the recently installed replacement section.

[IMG] [/IMG]

[IMG] [/IMG]

Boiler Not Heating Water

Craftsman Door Opener Old Weather Troubles

My Craftsman opener (not sure the model, I'm at work and cannot check. It's from the late 90s) works fine most of the time. However, it bitter cold (single digits), it refuses to close. it will start to close then reverse as if it hit an obstruction or something tripped the beam.



If I use the button on the garage wall and hold the button down until it closes, it will usually close OK. Sometimes, however, it will get fully closed then reverse and re-open.



I've tried adjusting the open & close force or the open / close limits (I seem to remember they are separate adjustments) but I'm not sure what I should be looking for. Any tips on adjusting this? I'm not sure that I have a manual, the previous owner installed the opener.

Craftsman Door Opener Old Weather Troubles

AC Coil Insulation

I had a new coil installed in a central air conditioner located in the upstairs closet last March. They put some kine of insulation over it with a paint brush. Now I notice it is feeling damp there, and the insulation stuff has come apart from the coil steel frame on the right side. I see no indication of any leaking water. Is this indication of some problem, or does it just need a little duct tape there? It is cool weather in Austin now and AC is not being used.

AC Coil Insulation

dimanche 15 février 2015

تفسير حلم السبحه فى المنام

تفسير حلم السبحه فى المنام

Popular Posts

Categories

Unordered List

Text Widget

Blog Archive

Followers

Fourni par Blogger.