I have just acquired a new (to me - actually very old) power saw with a 3-phase motor. I will be running it from a VFD fed by a 240V dedicated line.
I want to have a small worklight over it, and want to know if there's any safety / code reason I can't tap 120V off the 220V line to run it. The saw should draw about 12A max, the worklight will be an LED fixture of maybe 10W.
This is the planned wiring diagram....
Any advise or comments, please?
EDIT - Please disregard the 'attachment' diagram. I can't see how to remove it. The Neutral line does not go into the VFD.
Richard
I want to have a small worklight over it, and want to know if there's any safety / code reason I can't tap 120V off the 220V line to run it. The saw should draw about 12A max, the worklight will be an LED fixture of maybe 10W.
This is the planned wiring diagram....
Any advise or comments, please?
EDIT - Please disregard the 'attachment' diagram. I can't see how to remove it. The Neutral line does not go into the VFD.
Richard
0 commentaires:
Enregistrer un commentaire